Follow

140MM - Hub Reduction Output Seal Installation and Tool Cad

Additional note on installation of the factory seal: We are seeing these seals installed incorrectly quite often. The face of the seal is INSET by 5mm from the face of the housing. Quite common for us to see shops set the seal flush. When that is done the second lip of the seal is not riding on the wear ring properly. The factory tool has that 5mm step to set the correct inset. Here are a couple of pictures to highlight. If installing manually, you will need to make sure the deal is inset from the flange by that same 5mm.
Attached Thumbnails
Click image for larger version

Name:	IMG_0891.jpg
Views:	11
Size:	43.0 KB
ID:	1776593   Click image for larger version

Name:	IMG_0892.jpg
Views:	10
Size:	59.2 KB
ID:	1776601   Click image for larger version

Name:	IMG_0893.jpg
Views:	10
Size:	55.8 KB
ID:	1776609   Click image for larger version

Name:	IMG_0895.jpg
Views:	10
Size:	33.4 KB
ID:	1776617
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.